While at first glance removing a stuck mouthpiece can look fairly simple, it can be anything but.
The mouthpiece shank and the receiver both have specific tapers so the mouthpiece fits snug and doesn’t wiggle or leak air while playing. The mouthpiece may be stuck due to damage to the shank or the receiver. It might be dirty or it may have just been jammed on too tight.
In any scenario the proper way to remove the stuck mouthpiece without damage is to use a mouthpiece puller. There are many different pullers available on the market but the one we use here is a Bobcat or Accent brand.
You adjust the tool, with the screws, so that one side of the puller is pressing against the end of the receiver and the other side is pulling against the bottom of the mouthpiece cup.
Gently adjust the screws a little bit at a time, alternating sides, until the mouthpiece comes loose. Sometimes some light tapping with a small nylon/rawhide hammer may be used to persuade the mouthpiece loose.
If the mouthpiece does not break loose then PLEASE STOP. DO NOT use pliers, vise grips, door jams, a metal hammer or a torch to help out. You will only cause damage that has to be repaired.
We pull stuck mouthpieces for no charge. However, we do charge for damage done to an instrument while trying to pull a stuck mouthpiece incorrectly. If you don’t have the right tool, please check with your band director or bring your instrument in to us.